This oil drain adapter flange is designed to convert the outlet of the turbo from a flanged tube to the more common pipe thread. When
installed with the included gasket and hardware, this
flange allows the oil return tube to be attached using
any male 3/8ths NPT connector. Common solutions
involve adding a 3/8 NPT to -10AN adapter for steel
braided oil return lines, or a 3/8 NPT to barbed
adapter for oil hose solutions.
These flanges are constructed of 7075 Aluminum, which
is 15-20% stronger than 6061 Aluminum. The included
hardware meets or exceeds Grade 8 rating.
This hardware will fit most turbos, but may not fit
all. If the supplied hardware does not fit the buyer's
turbo, the buyer is responsible for providing their
own hardware. The included gasket is direct from an
approved Garrett Turbo distributor.
The sizes are below to allow you to use these for anything that meets the measurements, and so you can check your turbo to be 100% sure. The measurements are from hole center to center.
38mm -14B drain flange
44mm- T25 drain flange
50.8mm- T3, T3/T4
50.8mm- GT series
Price: 19.00 shipped |
